Making, Calibrating and Testing a Sensor
- Words:
- 1961
- Submitted:
- Tue Aug 25 2009

Have a little read: ... AS Instrumentation Task Making, Calibrating and Testing a Sensor Introduction The aim of my investigation is to produce a working sensor for use in any application of my choice. In order to do this you were required to choose a task for my sensor to carry out, and then choose an appropriate sensor to carry out the task. The sensors available for selection are an LDR, a linear resistor and a thermistor. However, for the sensor to be fully operation in its application it will be to be used alongside a resistor to give the right amount of sensitivity for the task, therefore I must also select a resistor. Then you must conduct an experiment to allow me to calibrate my sensor to make a fully functioning sensor. Description The scenario for which I have chosen to design my sensor for is for use in a garage. When cars park into garages it is useful
BETTER MARKS THAN I EVER HOPED FOR
A FANTASTIC HELP
Secure low cost access to the largest collection of model answers anywhere...
Finally, did you know, we are the only essay site certified as safe by the Credit Card industry? (100% PCI DSS compliant). You can feel 100% secure accessing the largest collection of model answers on the Internet - plus our very low price means even struggling students can afford to get help fast. Start now...
- Feel secure and in control - the ultimate stress buster
- We're the only site with over 1 Million monthly visitors
- You'll instantly spot winning structures and ideas - FAST!
- Backed by Anti-plagiarism experts
- Your revision, essays or coursework DONE! Just 17p!










